Points To Note When Using Ballpoint Pens

May 15, 2023

The angle is too small
Easy to wear the closure of the ball seat (the ball base material is nickel, platinum copper or stainless steel, much more easy to wear than the ball ball), such as long-term contact with the written object, even if the written object is paper, the ball seat can not withstand wear, which will cause the ball to fall off.


Correct angle
When writing with a ballpoint pen, the angle control of 55 ° to 70 ° is the most ideal, at this time, only the ball and the paper contact (the ball is very hard, tungsten carbide or ceramic, very difficult to wear), the closing does not contact the writing object, so as to ensure that the ballpoint pen in a good writing state to extend the service life.


The pad paper is too thick
When writing, the pad paper is too thick, the end of the pen contact with the paper, easy to wear and bead, it is recommended: 0.4 ball beads can not be rewritten; 0.5 ball beads can be copied up to 1 sheet, should not be more; 0.7 ball beads can be copied up to 3 to 4 sheets, should not be more, it is best to write at 75 ° when copying.


Dye
The role of dyes is to give the ink sufficient color depth, ballpoint pen ink used in the dye can be divided into oil-soluble dyes and alcohol-soluble dyes, the dye used in this test is phthalocyanine dyes, the dye is insoluble in solvent, in the ink has good dispersion, the film forming agent has strong adhesion, so as not to penetrate the inside of the paper, and the color to be bright color, good weather resistance.


Dispersants
The appropriate amount of dispersant can reduce the adhesion of the ink and the paper surface, so that the ink has erasability when writing to the paper surface for a certain period of time, and the dispersant can also maintain the fluency and long-term stability of the ink. The substances used in this experiment are mixtures of phthalates and ethylene glycol esters prepared in a certain proportion.


Film former
Film forming agent is an important part of the erasable ballpoint pen ink, its role is mainly to form a uniform film on the surface of the paper and serve as a carrier for dyes. It is required to have a certain adhesion to the paper performance, not easy to peel off, but can be gently wiped off with an eraser, and the colorant has strong adhesion, good solubility in the solvent, and is stable with other components, and can be stored for a long time. In this experiment, a rubber-based film former was used.

 

Solvent
In the erasable ballpoint pen ink, the role of the solvent is to dissolve the dye, film former and be compatible with various additives to provide certain fluidity, but also have just the right volatility, and can effectively control the drying speed during the writing process. The test shows that the co-solvent is better than the single solvent, and the co-solvent system of solvent A: solvent B=1:1.5~2.5 is used in this experiment, and the effect is the best.

 

Send Inquiryline